Filter
Top Products
D1260/D1260B | Owner's Manual | Part II: System Commands - MASTER ARM ? (COMMAND + 1)
Bosch Security Systems | 9/04 | 50410D 19
MASTER ARM ? (COMMAND + 1)
Description
Use this function to turn on the entire system, both
perimeter and interior. When you turn on the system,
the display shows how many seconds of exit delay time
you have to exit the protected area. You should leave
before exit delay time expires.
Leaving after exit delay has expired will cause the
entry delay to start. You may also cause an alarm on
an interior device. Enter your personal passcode to
disarm the system.
This function may be used by your cleaning service, a
serviceman, or others who need to turn on your system
when they leave.
Using Master Arm:
Using the COMMAND +1 shortcut will
only arm the area where the keypad has
been assigned. Example, if the D1260 is
assigned to Area 1, only Area 1 will be
armed when COMMAND + 1 is pressed.
1. The display shows disarmed idle text.
2. Press the COMMAND key.
3. The display shows
*System Command*
.
4. Press the 1 key
5. If your system is programmed to require a
passcode when performing a COMMAND 1, the
display prompts you to enter your passcode.
The passcode is shown as asterisks (*).
6. If the passcode has valid authority for this
command, the display shows
Exit now #
(# = exit
delay time remaining)
seconds remaining
.
After the exit delay time expires, the display
changes to idle armed text.
7. To disarm your security system, enter your
personal passcode and press ENTER.