Filter
Top Products
D1260/D1260B | Owner's Manual | Part III: Advanced Commands - SERVICE MENU ? (9 + 9 + Enter)
66 Bosch Security Systems | 9/04 | 50410D
If you know the point number, you can
enter it by pressing its number key and
then the ENTER key.
The display will change to show the point
that was entered. If the point is invalid the
message “Invalid Point” or “This is not a
valid walk point” appears.
Test each point by first opening and then closing
the door or window or other detection device.
Check the display after testing each point. For
interior points, walking past the device once is
sufficient. If any point does not test correctly,
contact your security company for service.
2. During the Walk Test you may want to see the
points that remain untested by pressing the
View
untested pts>
soft key.
The display shows
### pts untested.
Press the
Point information>
soft key to see
information about specific points that have not yet
been tested.
The display changes to show the information for
that point.
Move through this list by pressing the
Next
Point>
soft key.
Press the
<Exit
soft key to return to the
###
points remain to be tested.
before continuing the
Service Walk Test.
3. When all points have been tested,
0 points
remain to be tested
is displayed.
Press the
<Exit
soft key.
The display momentarily shows
All points have
been tested.
before returning to idle text.
Using Default Text
This function allows the current state of the area for 3
seconds before returning to idle text.
1. Press the
Default Text?>
soft key to display the
current state of the area.
2. The current state of the area is displayed for 3
seconds before returning to idle text.
Using Setup
The Setup function is accessed by pressing the
Setup?
> soft key.
The adjustable functions that are available in this menu
are:
• High Brightness,