Filter
Top Products
Appendix B Using BOOT Loader
Avaya M770 ATM Switch User’s Guide 285
Terminal Commands
These commands allow you to configure how the BOOT Loader in a M770 ATM
Switch displays output on the terminal.
Viewing the number of lines
If the pager is enabled, this is the number of lines that a M770 ATM Switch will
output before pausing. For more information about the pager, see Viewing the
pager status later in this chapter.
To display the current number of lines, use the terminal lines
command.
Setting the number of lines
To set the number of lines, use the terminal lines
command.
Viewing the terminal width
To display the current terminal width, use the terminal width
command.
Setting the terminal width
To set the terminal width, use the terminal width
command.
Viewing the wordwrap status
To display the wordwrap status, use the terminal wordwrap command.
Command:
M15-155s8:/>terminal lines
Output:
lines: 24
Command:
M15-155s8:/>terminal lines <rows>
Example:
M15-155s8:/>terminal lines 48
Parameter:
<rows>
The number of lines to be displayed on
the terminal.
Command:
M15-155s8:/>terminal width
Output:
terminal width 79
Command:
M15-155s8:/>terminal width <columns>
Example:
M15-155s8:/>terminal width 90
Parameter:
<columns>
The number of columns to be displayed on the
terminal.
Command:
M15-155s8:/>terminal wordwrap
Output:
no wordwrapping