
Avaya M770 ATM Switch User’s Guide 227
Chapter 17
Managing System Commands
This chapter describes how to use the command-line interface to manage the
system, and terminal commands. For information about how to access and use the
Avaya M770 ATM Switch command-line interface, see Chapter 3, “How to Use the
Command-line Interface”.
Using System Commands
This section describes system commands that are used to monitor or perform
operations on the Avaya M770 ATM Switch.
You can carry out the following system operations:
• Download and upload microcode
• View system exceptions
• Controlled shutdown of the switch
• Take a snapshot of the current system configuration
• Reboot the switch
• View memory allocations
• View time received from time server
• Set the module to its factory defaults
Downloading over TFTP
In order to download over TFTP (Trivial File Transfer Protocol), the remote file
server must be accessible from the ELAN to which the management LEC belongs or
from the MSPV Ethernet Sideband port. To verify this connectivity you should ping
from the file server to the IP of the LEC or to the IP of the M-SPV/M-SPX/M-SPS.