Filter
Top Products
74 Language Dictionary
MEM:TABL:CURR:POIN?
MEM:TABL:VOLT:POIN?
These commands return the number of current or voltage points in the active table.
Query Syntax MEMory:TABLe:CURRent[:MAGnitude]:POINts?
MEMory:TABLe:VOLTage[:MAGnitude]:POINts?
Returned Parameters <NRI> (number of points)
Examples MEM:TABL:CURR:POIN?
MEM:TABL:VOLT:POIN?
Related Commands MEM:TABL:VOLT MEM:TABL:CURR
MEM:TABL:CAT?
This command returns the names of all user-defined table.
Query Syntax MEMory:TABLe:CATalog?
Returned Parameters <STR> (all table names separated by commas)
Examples MEM:TABL:CAT?
“Table1”, “Table2”,”Table3”,” “ (“ “ = end of list)
Output Subsystem
Output commands control the Agilent SAS's voltage and current outputs and an optional output relay.
Source commands program the actual voltage, current, and protection functions.
OUTP
This command enables or disables the Agilent SAS output. The state of a disabled output is a condition of zero output
voltage and a model-dependent minimum source current (see Table 7-3). The query form returns the output state.
Command Syntax OUTPut[:STATe] <bool>
Parameters 0 | OFF | 1 | ON
*RST Value 0
Examples OUTP 1 OUTPUT:STATE ON
Query Syntax OUTPut(:STATe]?
Returned Parameters <NR1> 0 or 1
Related Commands *RST *RCL *SAV
OUTP:PROT:CLE
This command clears any OV (overvoltage), OC (overcurrent ), OT (overtemperature), or RI (remote inhibit) protection
features. After this command, the output is restored to the state it was in before the protection feature occurred.
Command Syntax OUTPut:PROTection:CLEar
Parameters (None)
Query Syntax (None)
Examples OUTP:PROT:CLE OUTPUT:PROTECTION:CLEAR