Filter
Top Products
Installation 19
2
Installation
Inspection
Damage
When you receive your Agilent SAS, inspect it for any obvious damage that may have occurred during shipment. If there is
damage, notify the shipping carrier and the nearest Agilent Sales and Support Office immediately. Warranty information is
printed in the front of this guide.
Packaging Material
Until you have checked out the Agilent SAS, save the shipping carton and packing materials in case the Agilent SAS has to
be returned to Agilent Technologies . If you return the Agilent SAS for service, attach a tag identifying the model number
and the owner. Also include a brief description of the problem.
Items Supplied
In addition to this manual, check that the following items in Table 2-1 are included with your Agilent SAS
Table 2-1. Items Supplied
Power cord
Your Agilent SAS was shipped with a power cord for the type of outlet specified for your location. If the
appropriate cord was not included, contact your nearest Agilent Sales and Support Office (see end of this
guide) to obtain the correct cord. Caution: The Agilent SAS cannot use a standard power cord. The
power cords supplied by Agilent Technologies have heavier gauge wire.
Analog
connector
A 7-terminal analog plug (see table 1-3 in chapter 1) that connects to the back of the unit. Analog
connections are described in chapter 4.
Digital
connector
A 4-terminal digital plug (see table 1-3 in chapter 1) that connects to the back of the unit. Digital
connections are described in appendix C - Digital Port Functions
Serial cable
A 2-meter cable (see table 1-2 in chapter 1) that connects to the control bus (next to the GPIB
connector). This cable is used to serially connect multiple supplies as described under Controller
Connections in Chapter 4.
Change page
If applicable, change sheets may be included with this guide. If there are change sheets, make the
indicated corrections in this guide.
Location and Temperature
Bench Operation
The Supplemental Characteristics in appendix A give the dimensions of your Agilent SAS. The cabinet has plastic feet that
are shaped to ensure self-alignment when stacked with other Agilent System II cabinets. The feet may be removed for rack
mounting. Your Agilent SAS must be installed in a location that allows sufficient space at the sides and rear of the cabinet
for adequate air circulation. Minimum clearances are 1 inch (25 mm) along the sides. Do not block the fan exhaust at the
rear of the unit.