2-408
Catalyst 6500 Series Switch Command Reference—Release 8.1
78-15474-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
set port debounce
For 10/100 ports and 100BASE-FX ports in the disabled state, the firmware may take up to 600
milliseconds to notify the supervisor engine of a link change because the firmware polling time is every
300 milliseconds.
For 10/100 ports and 100BASE-FX ports in the enabled state, the firmware may take up to 3400
milliseconds to notify the supervisor engine of a link change because the firmware polling time is every
300 milliseconds.
Examples This example shows how to enable the debounce timer for a specific port on a specific module:
Console> (enable) set port debounce 1/1 enable
Debounce is enabled on port 1/1.
Warning:Enabling port debounce causes Link Up/Down detections to be delayed.
It results in loss of data traffic during debouncing period, which might
affect the convergence/reconvergence of various Layer 2 and Layer 3
protocols.
Use with caution.
Console> (enable)
Related Commands show port debounce
