2-1017
Catalyst 6500 Series Switch Command Reference—Release 8.1
78-15474-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
show radius
show radius
To display configured RADIUS parameters, use the show radius command.
show radius [noalias]
Syntax Description
Defaults This command has no default settings.
Command Types Switch command.
Command Modes Normal.
Usage Guidelines You can enter this command in normal or privileged mode, but the RADIUS key is displayed only if this
command is entered in privileged mode.
Examples This example shows how to display RADIUS information:
Console> show radius
Login Authentication: Console Session Telnet Session
--------------------- ---------------- ----------------
tacacs disabled disabled
radius disabled disabled
local enabled(primary) enabled(primary)
Enable Authentication: Console Session Telnet Session
---------------------- ----------------- ----------------
tacacs disabled disabled
radius disabled disabled
local enabled(primary) enabled(primary)
RADIUS Deadtime: 0 minutes
RADIUS Key: 123456
RADIUS Retransmit: 2
RADIUS Timeout: 5 seconds
Framed-Ip Address Transmit: Enabled
RADIUS-Server Status Auth-port Acct-port
----------------------------- ------- ------------ ------------
10.6.140.230 primary 1812 1813
Console>
noalias (Optional) Forces the display to show IP addresses, not IP aliases.
