Chapter 11. Dial Plan
61200305L1-1 ATLAS 550 User Manual 11-31
Figure 11-10. Call Routing Table for Routing Using Call Party Number
PKTVOICE
The ATLAS 550 provides the same level of capability for packet-switched
voice as originally provided for circuit-switched voice.
I
FCE
C
ONFIGURATION
(under D
IAL
P
LAN
>U
SER
T
ERM
or N
ETWORK
T
ERM
)sets
configuration parameters for the endpoint. These parameters vary by the
type of port selected. The following section describes the configuration op-
tions available for packet-switched voice (see Figure 11-11).
The first step in configuring the D
IAL
P
LAN
for packet voice is to select
N
ETWORK
T
ERM
or U
SER
T
ERM
. Refer to Connecting Packet Endpoints in Frame
Relay on page 11-28 for determining whether to use N
ETWORK
T
ERM
or U
SER
T
ERM
.(SeealsoMenus for Network Termination on page 11-33 and Menus for
User Termination on page 11-34.) Once this selection is made, a number of
fields become available. These fields are discussed in the following sections.
Figure 11-11. Packet Switched Voice Options
S
LOT
/S
VC
Write Security: 3; Read Security: 5
Select PKT
V
OICE
as the service.
P
ORT
/PEP Write Security: 3; Read Security: 5
Select the port/packet endpoint that you want to configure.
S
IG
Not used for packet voice.
I
N
#A
CCEPT
Write Security: 3; Read Security: 5
Configured as defined in In#Accept on page 11-6.
O
UT
#R
EJ
Write Security: 3; Read Security: 5
Configured as defined in Out#Rej on page 11-8.
I
FCE
C
ONFIG
Write Security: 3; Read Security: 5
Provides interface configuration parameters (see Figure 11-12).
