Chapter 8. Packet Manager
8-8 ATLAS 550 User Manual 61200305L1-1
N
ET
P
OLLS
P
ER
S
TATUS
(N391)
Sets the number of link integrity polls before a full status is transmitted.
N
ET
B
AD
E
VENTS
T
HRESHOLD
(N392)
Sets the number of bad polling events that will cause the link to be declared
down in N393 Polls.
N
ET
E
VENT
W
INDOW
S
IZE
(N393)
Defines the number of poll events in each monitored window.
S
UBLINKS
Write Security: 3; Read Security: 5
Allows PVC creation and configuration within a frame relay link that uses
sublink DLCIs. Sublinks are not supported in TBOP.
N
AME
User-defined name for the DLCI.
DLCI
Local address for each PVC as assigned by the carrier.
QOS
Quality of service. These values can be used to assign a guaranteed amount
of bandwidth available for this connection. The sum of all QOS values for
the sublink should not exceed the Committed Information Rate (CIR).
B
URST
Sets the burst to be used by this virtual circuit for data traffic. A value of
zero means that the burst rate is not limited. The value is in kilobits/second
(kbps). The B
URST
rate defines by what amount this virtual circuit is
allowed to exceed the CIR.
If voice traffic is flowing on any sublink on the port carrying this sublink,
you should enter a value for this setting. Otherwise, leave this as zero. If the
service provider has supplied a “Be” value, use that value for this setting. If
the service provider has not supplied an excess burst rate, enter the wire
speed in this field.
C
ONFIG
Allows configuration of parameters for each DLCI.
Ensure that this timer is greater than the T391 on the user side of the
UNI; otherwise, erratic behavior will result.
If the number of bad polls reaches N392 in any N393 period, the
link will be declared down. When N393 good polls are received,
the link will be declared active again.
