Chapter 11. Dial Plan
11-28 ATLAS 550 User Manual 61200305L1-1
CONNECTING PACKET ENDPOINTS IN FRAME RELAY
After packet endpoints are created, they must be connected to a physical
port. You can connect the endpoints using either the D
EDICATED
M
AP
(see
Chapter 10) or the D
IAL
P
LAN
. As described here, the D
IAL
P
LAN
associates a
phone number with the endpoint.
You can enter two types of packet-switched endpoints into the D
IAL
P
LAN
:
Packet Endpoints (P
KT
E
NDPT
)andPacketVoice(P
KT
V
OICE
). See Figure 11-5.
When using P
KT
E
NDPT
, endpoints are entered via U
SER
T
ERM
. When using
P
KT
V
OICE
, endpoints are entered via N
ETWORK
T
ERM
or U
SER
T
ERM
.(Seeal-
so, Menus for Network Termination on page 11-33 and Menus for User Termina-
tion on page 11-34.)
Figure 11-5. Dial Plan Menu for Endpoints
PKTENDPT
To facilitate dial-up packet services, the ATLAS 550 D
IAL
P
LAN
supports
packet endpoints which must be entered in the USER
T
ERM
menu. The U
SER
T
ERM
menu includes S
LOT
/S
VC
, P
ORT
/PEP, S
IG
, I
N
#A
CCEPT
, O
UT
#R
EJ
,and
I
FCE
C
ONFIG
.
S
LOT
/S
VC
Write security: 3; Read security: 5
Selects the service. Select PKT
E
NDPT
.
P
ORT
/PEP Write security: 3; Read security: 5
Accepts the packet endpoint you wish to configure. Select from a specific
packet link that was configured with the P
ACKET
M
ANAGER
menus or select
G
ROUP
(see Figure 11-6 ). The G
ROUP
option allows you to define a hunt group.
The interface configuration (I
FCE
C
ONFIG
) parameters vary, depending on
whether a specific packet link (endpoint) or the G
ROUP
option is selected.
