Filter
Top Products
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
4
NOTE: This provides an alternative
method for identifying your door
sections/stacking position.
Hinges are always pre-attached at
the top of each section (except top
section) and the hinges are stamped
for identification, #1, #2, #3, and #4 (#4
only on five section doors). See view
below. The stamp identifies the stacking
sequence of the section. The sequence
is always determined by #1 being the
bottom section to #3 or #4 being the
highest intermediate section. See views
to the right. If the stamp on the end
hinge is illegible, refer to the section
side view illustration to the right.
The section side view illustration shows
the end hinge profile of all the sections,
and can also be used in conjunction
with identifying each sections.
The BOTTOM SECTION can be
identified by #1 end hinges, the factory
attached bottom astragal, and by the
bottom bracket warning labels on each
end stile.
The LOCK SECTION can be identified
by a #2 end hinge.
The INTERMEDIATE SECTION can be
identified by #3 end hinges. The section
will have a warning label attached to
either the right or left hand end stile.
NOTE: #4 End hinges are used on the
fourth section of five section doors.
The TOP SECTION can be identified
with no pre-installed end or center
hinges and U-bar attached to the top
section.
SECTION SIDE VIEW
TYPICAL HINGE STAMPING LOCATION
Door Section Identification
TOP SECTION
INTERMEDIATE SECTION
LOCK SECTION
BOTTOM SECTION
BOTTOM BRACKET
WARNING LABELS
ASTRAGAL
#3
WARNING LABEL
(MAY BE ON RIGHT OR LEFT HAND SIDE)
#2
#1
1 3/8”
1 1/8”
7/8”
#1 END
HINGE
#2 END
HINGE
#3 END
HINGE
ASTRAGAL
BOTTOM
BRACKET
BOT.LOCK
INT.
TOP
U-BAR