Filter
Top Products
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
24
idrive
®
Installation
NOTE: See idrive
®
main installation and
owners manual for idrive
®
parts.
IMPORTANT: RIGHT AND LEFT HAND
IS ALWAYS DETERMINED FROM INSIDE
THE GARAGE LOOKING OUT.
Lay the TorqueMaster
®
spring tube on
the floor (inside garage) in front of the
door with the labeled end to the left.
Look into the opener’s left side to
ensure the left hand bearing and the
internal (black) sleeve are aligned with
the TorqueMaster
®
spring tube profile.
IMPORTANT: HOLD OPENER BY THE
MAIN BODY. DO NOT HOLD BY THE
MOTOR.
NOTE: Opener will not slide over THE
TorqueMaster
®
spring tube label.
Attempting to slide opener over the left
end of the TorqueMaster
®
spring tube
can damage the internal electronics.
Once aligned, slide the opener onto the
right hand end of the TorqueMaster
®
spring tube. As the right end of the
TorqueMaster
®
spring tube enters the
internal (black) sleeve, rotate the
opener back and forth slightly to help
aid alignment.
Continue sliding the opener onto the
TorqueMaster
®
spring tube. Align the
right hand bearing with the
TorqueMaster
®
spring tube and slide
the opener completely onto the
TorqueMaster
®
spring tube until the
TorqueMaster
®
spring tube exits the
opener’s right hand bearing.
NOTE: If misalignment occcurs do not
force opener onto TorqueMaster
®
spring
tube.
Continue sliding the opener to the
center of the TorqueMaster
®
spring
tube.
Plug the motor power cord into the
opener.
LEFT HAND SIDE
TORQUEMASTER
®
SPRING TUBE
AND BEARING PROFILES ALIGNED
RIGHT HAND END
OF TORQUEMASTER
®
SPRING TUBE
RIGHT HAND SIDE
TORQUEMASTER
®
SPRING TUBE AND
BEARING PROFILES
ALIGNED
PLUG-IN MOTOR
POWER CORD
MOTOR
18