Filter
Top Products
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
29
Tools Needed:
Tools Needed:
DISCONNECT
CABLE
S-HOOK
HOLE IN RIGHT
END BRACKET
CLOSE “S” HOOK
HOLE IN
END BRACKET
RIGHT SIDE OF
END BRACKET
(2) 1/4” X 1-1/2”
LAG SCREWS
DISCONNECT
HANDLE BRACKET
6 ft.
NOTE: See idrive
®
main installation and
owners manual for idrive
®
parts.
Attach the loose disconnect cable
(located in opener hardware bag) to the
opener with the “S” hook. Close both
ends of the “S” hook with pliers, to lock
assembly together.
Thread the disconnect cable (behind the
counterbalance cable) through the hole
in the right hand end bracket. Remove
all slack between opener and right end
bracket.
Attaching Disconnect Cables
Pliers
Mounting Disconnect
Handle Bracket
Pencil
Tape measure
1/8” Drill Bit
7/16” Socket
Driver
Power Drill
NOTE: See idrive
®
main installation and
owners manual for idrive
®
parts.
Mark a location on the right jamb, 6
feet above the floor to mount the
disconnect handle bracket.
Drill 1/8” pilot holes for the lag screws.
Align top of the bracket with the mark.
Fasten bracket to the jamb with
(2) 1/4” x 1-1/2" lag screws.
25
26
INSTALLATION