Filter
Top Products
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
31
Tools Needed:
Tools Needed:
FAILURE TO PLACE VICE
CLAMPS ONTO VERTICAL TRACK
CAN ALLOW DOOR TO RAISE
AND CAUSE SEVERE OR FATAL
INJURY.
Place vice clamps onto both vertical
tracks just above the third roller. This is
to prevent the garage door from raising
while winding counterbalance springs.
IMPORTANT: DO NOT USE IMPACT GUN
TO WIND SPRING(S).
Securing Door
for Spring Winding
TRACK
VICE CLAMPS
ATTACHED TO
INNER RAIL
OF TRACK
Vice Clamp
COUNTERBALANCE
CABLE
SET SCREW
CABLE
DRUM
Locking Pliers
Flat Tip
Screwdriver
CAM PEAK
STRAIGHT UP
Rotate the cable drum until the set
screw faces directly away from the
header. TorqueMaster
®
Spring Tube
cam peak should be pointing straight
up.
Beginning with the right side, loosen
the set screw enough to adjust cable,
approximately 2 turns. Using locking
pliers, pull on the end of the cable to
remove all cable slack.
Check to ensure the cable is aligned
and seated in the first groove of the
cable drum. Snug the set screw, then
tighten an additional 1-1/2 turns. Cut
excess cable.
Cable Adjustments
WARNING
28
29
PLACE VICE
CLAMPS ABOVE
3RD ROLLER
INSTALLATION