Filter
Top Products
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
37
Trolley Operator
OPERATOR MUST BE TESTED AT TIME
OF INSTALLATION AND MONTHLY
THEREAFTER TO ENSURE THAT DOOR
REVERSES ON CONTACT WITH 2 X 4
BOARD LAID FLAT UNDER THE DOOR.
FAILURE TO ADJUST OPERATOR,
IF NECESSARY, CAN RESULT IN SEVERE
OR FATAL INJURY. IF YOUR OPERATOR IS
EQUIPPED WITH A PHOTOELECTRIC EYE
SYSTEM, THEN THIS MUST BE TESTED AT
THE SAME TIME TO ENSURE THAT DOOR
DOES NOT CLOSE AND A CLOSING DOOR
OPENS IF PHOTOELECTRIC EYE SYSTEM
IS OBSTRUCTED. FAILURE TO MAKE
ADJUSTMENTS, IF NECESSARY, CAN
RESULT IN SEVERE OR FATAL INJURY.
1. Install operator rail 1/2” to 1-1/2”
(13 - 38 mm) above high arc of top
section of the door.
2. Mount operator to ceiling so that
1” to 1-1/2” (25 - 38 mm)
clearance is maintained between
trolley rail and top section when
door is fully open (trolley rail will
slope down towards rear).
3. Attach door arm to operator bracket
installed in Step 10.
4. Attach operator rail to suitable
mounting surface, 2 x 6 lumber
minimum.
5. Attach operator to ceiling using
perforated angle.
IMPORTANT! ANGLES MUST BE
SECURELY ATTACHED TO SOUND
FRAMING MEMBER(S).
HEADER
OPERATOR
FRAMING MEMBERS
PERFERATED ANGLE
OPERATOR
RAIL
PERFERATED
ANGLE
OPERATOR RAIL
❉
WARNING
SUITABLE
MOUNTING
SURFACE (2 X 6)
LUMBER MIN.
DOOR ARM TO OPERATOR
BRACKET
OPTIONAL INSTALLATION