Filter
Top Products
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
35
Tools Needed:
Tools Needed:
Side Lock
Install the side lock on the second
section of the door. Secure the lock to
the section with (4) 1/4”- 20 x 11/16”
self drilling screws. Square the lock
assembly with the door section and
align with the square hole in the vertical
track. The side lock should be spaced
approximately 1/8” from the section
edge.
IMPORTANT: SIDE LOCKS MUST BE
REMOVED OR MADE INOPERATIVE IN
THE UNLOCKED POSITION IF AN
OPERATOR IS INSTALLED ON THE DOOR.
NOTE: After completing this step,
continue with step 10 on page 17.
❉
(4) 1/4”- 20 X 11/16”
SELF DRILLING SCREWS
1/8”
Power Drill
7/16” Socket
Driver
DoorMaster
TM
Bracket
NOTE: When installing a DoorMaster
TM
operator use the center bracket and
drive gear supplied with your operator
(located in DoorMaster
TM
package).
Slide the DoorMaster
TM
bracket/drive
gear assembly onto the TorqueMaster
®
Spring Tube, so that the drive gear/
center bracket assembly are in the
center of the TorqueMaster
®
Spring Tube.
NOTE: After completing this step,
continie with step 19 on page 25.
Power Drill
1/8” Drill Bit
❉
TORQUEMASTER
®
TUBE
A
A
DOORMASTER
TM
BRACKET/
DRIVE GEAR ASSEMBLY
Locate the center bracket, mark the
header halfway between the flagangles
and level the TorqueMaster
®
Spring Tube.
Drill 1/8” pilot holes for the lag screws.
Fasten the metal bracket to the header
using (2) 1/4” x 1-1/2” lag screws.
NOTE: After completing this step, continie
with step 28 on page 31.
B
B
Tools Needed:
Power Drill
1/8” Drill Bit
7/16” Socket
Driver
DOORMASTER
TM
BRACKET/
DRIVE GEAR
ASSEMBLY
INSTALLATION