Filter
Top Products
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
23
Tools Needed:
Tools Needed:
TorqueMaster
®
Spring Tube
TorqueMaster
®
springs come lubricated
and pre-assembled inside the
Torquemaster
®
spring tube. To install, lay
the Torquemaster
®
spring tube on the
floor (inside garage) in front of the door
with the labeled end to the left.
IMPORTANT: RIGHT AND LEFT HAND IS
ALWAYS DETERMINED FROM INSIDE THE
GARAGE LOOKING OUT.
LABELED END
TORQUEMASTER
®
SPRING TUBE
None
16
17
Center Bracket Bushing
NOTE: If you are installing the idrive
®
opener on your garage door, skip this step
and continue with Step 18.
NOTE: If you are not installing the
idrive
®
opener on your garage door, you
must install the center bracket bushing
assembly. Follow these instructions for
non-idrive
®
operated garage doors.
NOTE: If you are installing a DoorMaster™
opener, see optional DoorMaster™
Bracket installations on page 35, Figure A.
Being cam shaped the center bracket
bushing only fits one way.
Slide the center bracket assembly towards
the center of the Torquemaster
®
spring
tube, from the right side as shown.
NOTE: Upon completion of this step,
continue with Step 19.
CENTER
BRACKET
ASSEMBLY
TORQUEMASTER
®
SPRING TUBE
TORQUEMASTER
®
SPRING TUBE
CENTER
BRACKET
BUSHING
INSTALLATION