Filter
Top Products
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
14
Tools Needed:
Drums
IMPORTANT: RIGHT AND LEFT HAND IS
ALWAYS DETERMINED FROM INSIDE THE
BUILDING LOOKING OUT.
NOTE: For door section identification see
page 4.
TorqueMaster
®
Counterbalance Drums
are marked right and left hand. Uncoil
the counterbalance cables and make
sure you place the right hand cable loop
on the right hand milford pin and place
the left hand cable loop on the left hand
milford pin. Insert a roller into bottom
bracket of the bottom section and insert
another roller at #1 end hinge at the top
of the bottom section. Repeat for other
side.
NOTE: Verify astragal (bottom seal)
is aligned with door section. If there
is more than 1/2” excess astragal on
either side, trim astragal even with door
section.
None
LEFT HAND
TORQUEMASTER
®
COUNTERBALANCE DRUM
BOTTOM SECTION
MILFORD PIN
ROLLERS
#1 END HINGE
(HINGE TUBE)
BOTTOM BRACKET
BOTTOM
SECTION
ASTRAGEL
6
BOTTOM SECTION
COUNTERBALANCE
CABLE
QUICK INSTALL FEATURE
None
5
Installing Q.I. Jamb Brackets
TOP
HOLE
BOTTOM
HOLE
MIDDLE
HOLE
3RD SET HOLES
2ND SET HOLES
1ST SET HOLES
QI JAMB BRACKET
TWISTLOCK TAB
LEFT SIDE SHOWN RIGHT SIDE SHOWN
JAMB BRACKET SCHEDULE
DOOR
HEIGHT
1ST SET 2ND SET 3RD SET
JAMB
BKT
POS.
JAMB
BKT
POS.
JAMB
BKT
POS.
8’0” TRACK QIJB - 3 MIDDLE QIJB - 6 TOP QIJB - 7 MIDDLE
NOTE: If you have fully adjustable jamb
brackets, skip this step and complete
Step 6.
Measure the length of the vertical
tracks. Using the jamb bracket schedule,
determine the placement of the jamb
brackets for your door height and track
type. To install the jamb brackets, align
the twistlock tab on the quick install
jamb bracket with the quick install
feature in the track and turn the bracket
perpendicular to the track so the
mounting flange is toward the back (flat)
leg of the track.
NOTE: After completing this step,
continue with Step 6.