Filter
Top Products
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
34
Attach horizontal tracks to the rear
supports with 5/16”-18 x 1-1/4” hex bolts
and nuts (may not be supplied). Horizontal
tracks must be level and parallel with door.
NOTE: If rear supports are to be installed
over drywall, use 5/16” x 2” hex head lag
screws.
NOTE: If an idrive
®
opener is installed,
position horizontal tracks one hole above
level when securing it to rear supports.
Adjust weather seal or door stop (if
necessary) Now permanently attach the
weather seal or door stop to both door
jambs and header. (They were temporarily
attached in PREPARING THE OPENING on
page 10.) Avoid pushing weather seal or
door stop too tightly against face of door.
PRIOR TO WINDING OR MAKING
ADJUSTMENTS TO THE SPRINGS,
ENSURE YOU’RE WINDING IN THE
PROPER DIRECTION AS STATED IN
THE INSTALLATION INSTRUCTIONS.
OTHERWISE THE SPRING FITTINGS MAY
RELEASE FROM SPRING IF NOT WOUND
IN THE PROPER DIRECTION AND COULD
RESULT IN SEVERE OR FATAL INJURY.
Now, lift door and check it’s balance.
Adjust, if door lifts by itself (hard to pull
down) or if door is difficult to lift (easy to
pull down). Anytime spring adjustments
are made you must loosen the lock nuts
before beginning adjustments. Retighten
both lock nuts after completion. To adjust
spring(s), only add or remove 1/4 turn on
the counter at a time. Adjust both sides
equally.
IMPORTANT: DO NOT ADD OR REMOVE
MORE THAN 1 SPRING TURN FROM
SPECIFIED AMOUNT. IF THE DOOR STILL
DOES NOT OPERATE EASILY, LOWER THE
DOOR TO THE CLOSED POSITION, UNWIND
SPRING(S) TO ZERO, AND RECHECK THE
FOLLOWING ITEMS:
1.) Check the door for level.
2.) Check the TorqueMaster
®
spring tube
and flagangles for level and plumb.
3.) Check the distance between the
flagangles - must be door width
plus 3-3/8” to 3-1/2”.
4.) Check the counterbalance cables
for equal tension - adjust if
necessary.
5.) Rewind the spring(s).
6.) Make sure door isn’t rubbing on
jambs.
NOTE: As a safety feature, the right hand
end bracket cannot be disassembled
for service until the spring is completely
unwound and the counter cover reads
zero.
After door installation is completed, refer
to the idrive
®
owner’s manual.
Rear Support Continued...
PERFORATED ANGLE
(3) 5/16”
BOLTS & NUTS
HORIZONTAL TRACK
BOLT MUST EXTEND INTO
THE TRACK TO SERVE AS
A ROLLER STOP
ANGLE BRACE
PERFORATED ANGLE -BOLTED
USING (2) 5/16” X 1-5/8” HEX
HEAD LAG SCREWS TO CEIL-
ING MEMBER AND PARALLEL
TO DOOR
SOUND FRAMING MEMBERS
SOUND FRAMING MEMBERS
HORIZONTAL TRACK
BOLT MUST EXTEND INTO
THE TRACK TO SERVE AS
A ROLLER STOP
JAMB
WEATHER
SEAL
PERMANENTLY ATTACHED
WEATHER SEAL OR DOOR STOP
ANGLE BRACE
PERFORATED ANGLE -BOLTED
USING (2) 5/16” X 1-5/8” HEX
HEAD LAG SCREWS TO CEIL-
ING MEMBER AND PARALLEL
TO DOOR
WARNING