Wayne-Dalton 9800 Series Garage Door Opener User Manual


 
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
19
Top Section
Place the top section in the opening
and vertically align with lower sections.
Align vertical marks in the upper
alignment sticker, with the lower
alignment sticker on right hand side on
the back of door. Temporarily secure
the top section by driving a nail in the
header near the center of the door and
bending it over the top section.
Now, flip up hinge leafs, hold them
tight against section and fasten center
hinges first and end hinges last. (Refer
to Step 9).
When installing a door with a
TorqueMaster
®
counterbalance system,
vertical track alignment is critical.
Position flagangle between 1-11/16”
(43 mm) to 1-3/4” (44 mm) from the
edge of the door. Flagangles must be
parallel to the door sections. Now,
complete the vertical track installation
by securing the center jamb bracket
and tightening the other lag screws.
Repeat for other side.
IMPORTANT: THE DIMENSION
BETWEEN THE FLAGANGLES MUST BE
DOOR-WIDTH PLUS 3-3/8” (86 MM) TO
3-1/2” (89 MM) FOR SMOOTH, SAFE
DOOR OPERATION.
For quick install track:
Complete the vertical track installation
by securing the center jamb bracket(s)
and tightening the other lag screws.
Repeat for opposite side.
For fully adjustable track:
Complete the vertical track installation
by securing the center jamb bracket(s)
and tightening the other lag screws.
Push the vertical track against the
rollers so that the rollers are touching
the deepest part of the curved side of
the track (see illustration); tighten all
the track bolts and nuts. Repeat for
opposite side.
12
Hammer
DOOR WIDTH
+3-3/8” TO 3-1/2”
FULLY ADJUSTABLE
1-11/16” TO 1-3/4”
FLAGANGLE
TOP
SECTION
NAIL
ROLLER
VERTICAL TRACK
ROLLER AGAINST
VERTICAL TRACK
TOP SECTION
INSTALLATION
327985 NEW 9-04-06
327985 NEW 9-04-06
RIGHT END HINGE SIDE
ALIGNMENT STICKERS