Filter
Top Products
14
VFR-400 • 5403548 • REV D • 10/07
}
ZONE 1
ZONE 2
ZONE 3
ZONE 4
OUTPUT 1
OUTPUT 2
OUTPUT 3
OUTPUT 4
AC POWER
POWER TBL
SYSTEM TBL
SUP TBL
GROUND
FA ULT
SUPERVISORY 1
SUPERVISORY 2
COMMON ALARM
ALARM SILENCE
STEADY: DISCHARGE
FLASHING:
PRE-DISCHARGE
RUN
PROGRAM
VIEWING ANGLE
PROGRAM
MODE
RUN
MODE
SET
SELECT
FUNCTION
SCROLL-UP
BUZZER SILENCE
LAMP
TEST
SCROLL-DOWN
BUZZER SILENCE
SIGNAL SILENCE
SYSTEM RESET
DWG# 3550-18VKG
Programming Mode Instructions
To use the Programming Mode push the program switch down (see drawing below).
Panel Visual Display
As a general rule, the following applies on the Programming Mode buttons:
The top button (SET) sets the message on the display into the memory.
The middle button (SELECT) scrolls through the selections available for the function displayed.
The bottom button (FUNCTION) allows the user to skip the function without changing the program.
To program, push the Program Switch down.
There is no capability to back up screens in the program mode. If a mistake was made during programming, move the program
switch back up, then move it down and start from the beginning.
To exit the program mode at any time, move the Program Switch up.
When the programming switch is down (see Panel Visual Display) the following will appear in the display window:
History
To examine the HISTORY press the top button, the display window will show the time and date of the last event or action. To skip
to the next function or to exit history, press the FUNCTION (bottom) button.
SET Press the SET button to discover the time and date of the last event or action and to scroll forward.
SELECT To scroll back, press the SELECT button.
FUNCTION To exit or skip HISTORY, press the bottom button.
LOOK AT
HI S TORY?