Filter
Top Products
ISDN
Program *68-1 – Calling Number ID Presentation Parameters
Strata DK Programming 5/99 7-33
ISDN
Program *68-1 – Calling Number ID Presentation
Parameters
Processor Type:
DK40i, All RCTUs (Release 4.0 or higher)
Program Type:
Trunk, PRI and BRI
Initialized Default:
all LEDs OFF
Program *68-1 Overview
This program assigns the Number Privacy feature, which allows the caller to prevent the public
network from delivering the Calling Number to the called party on a per-call basis. The Public
Switched Telephone Network (PSTN) may still provide a network-based Caller ID, even when the
outgoing Caller ID is OFF Only a subscription parameter can change that.
LED 01: Outgoing Caller ID
Service subscribers can request from the public network that the number be presented or not as a
default.
LED 02: Outgoing Caller ID Status Change
If a public telco service allows changes to be made, then a user can enter change a code to the
setting for that call after selecting a trunk group.
LED 03: Incoming Caller ID Source
When LED 03 is ON, the calling number with the call setup message is provided by the network;
OFF indicates that this information is sent from the caller. The Strata DK handles the number the
same way that ANI information from T1 trunks is handled. For instance, the number can display
on the called telephone’s LCD, or it can be used by TAPI interfaces, or it can be recorded in
SMDR data records.
The PSTN may send one or two Caller ID messages for incoming calls. One message is the Caller
ID supplied by the network, which is generally the billing number, while the second is the user
generated number. The Strata DK will use the user-supplied number, if required.
Note Individual callers can choose to block this information, regardless of this setting.
LED
Caller ID Setting
Trunk Groups
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1
Outgoing Caller ID
(ON = Allowed / OFF = Not Allowed)
2
Outgoing Caller ID Status Change:
ON = Allowed / OFF = Not Allowed
3
Incoming Caller ID Source:
ON = Network Provided OFF = Caller Provided
DATA = Press LED Buttons 01~03 for the
desired Calling Number ID parameters.
See table below.
Enter the Trunk Group
(01~16)
SEL = 1