Filter
Top Products
System & Station
Program 30 – Station Class of Service
3-76 Strata DK Programming 5/99
If a Tie or DID line is Dial Pulse (Program 15-1, LED ON), enable Dial Pulse - DTMF OFF (LED
11 ON) for that Tie or DID station port number. If the DID or Tie line is DTMF tone dial (Program
15-1, LED OFF) disable Dial Pulse - DTMF OFF (LED 11 OFF) and install an RRCS on the
RCTU, K5RCU, K5RCU2, or K4RCU3 in the DK40i.
LED 10: Change DISA Security Code
When enabled (LED 10 ON), allows a selected station to change the DISA security code by
dialing [PDN] +
, + Security Code + 5HGLDO.
LED 09: Change Toll Restriction (TR) Override Code
When enabled (LED 09 ON), two TR Override codes are available. When one of these codes is
dialed from any station, all Toll Restriction is bypassed. Change TR Override codes by pressing
[PDN] +
for Code 1, or [PDN] + for Code 2. Press 5HGLDO to store.
LED 08: Forced Account Code
When enabled, (LED 08 ON), a station or DISA CO line user using a line with a Forced Account
requirement (Program 15-7) must enter an Account Code before the outgoing CO/Tie/DID line
call can be completed. If Forced Account Codes should be verified, enable Verified Account Code
(LED 14 ON). Program 60-4 defines the Forced Account Code digit length.
To force a verified account code entry on Two-CO line DISA calls through the system, (LED 08
and 14 ON: Port 10-DK14, Port 035-DK40i, Port 039-RCTUA, Port 089-RCTUB, RCTUBA/BB,
249-RCTU C/D, and Port 344 for RCTU E/F). Also, enable Forced Account Code for outgoing
CO line in Program 15-7.
LED 07: Off-hook Call Announce (OCA) Automatic
When LED 07 is ON, a calling station has this feature enabled. If the system is set for Ring First
Signaling (Program 10-1, LED 10 ON), the user must dial
after hearing busy tone or after
hearing ringback tone in order to OCA the called station. OCA Automatic only works on systems
with Voice First Signaling (Program 10-1 or 10-2, LED 01, OFF) in which case the user does not
have to dial
or . Initialized default: ON - all ports. The called station must also be enabled to
receive OCA (see Program 31, LED 03).
LED 06: Automatic Busy Redial (ABR) Access
ABR can be enabled (LED 06 ON) or disabled (LED 06 OFF) for each station. The system selects
the last line in the originating line group each time ABR is initiated (see also Program 10-1). If you
do not enable ABR access here, the ABR soft key does not appear on LCD telephones. ABR
operates when calling on ground and loop start lines, but is not functional for DID or Tie line calls.
ABR overrides Program 41. Program 41 is normally used with LCR.
For the DK40i, K5RCU, K5RCU2, or K4RCU must be installed; for the DK14, QRCU must be
installed to detect busy tone so that ABR will function.
LED 05: Speed Dial
LED 04 enables (ON) or disables (OFF) Station and System Speed Dial. Initialized default: ON -
all ports.