Filter
Top Products
Initialization & Test
Program 91-1 – Automatic PCB Recognition and Port Renumber
2-6 Strata DK Programming 5/99
Program 91-1 – Automatic PCB Recognition and Port
Renumber
Processor Type:
DK14, DK40i, All RCTUs
Program Type:
Initialization
Initialized Default:
None
Program 91-1 Overview
Program 91-1 makes slot code assignments to installed PCBs that do not have options - such as a
PDKU without a Data Interface Unit or Off-hook Call Announce (OCA), the common control
without a Dual-tone Multi-frequency Receiver (RRCS), K5RCU, QRCU3, etc.
Program 91-1 also sets physical and logical ports to their initialized settings - even if you
previously relocated them. (See Program 01 and 02 for initialized settings.). Programs 04, 04, 05,
05, 09, or 71 are not affected.
CAUTION! Running Program 91-1 drops all calls.
Important! To identify Program 03 PCB slot codes, run Program 91-1 after you install all
PCBs.
Notes
● You can run Program 91-1 after setting PCB option codes with Program 03; this does not erase
option codes. For example, if Slot 00 is assigned code 92, Program 91-1 will not erase the
codes previously assigned with Program 03.
● If you install PCBs before initializing the system with Program 91-9, it is not necessary to run
Program 91-1 to assign the Program 03 PCB slot codes for the installed PCBs. You must
always run Program 03 to identify PCB options such as K5RCU, QRCU3, and RRCS codes
92, 93 and 94 and PDKU codes 61, 62, and 64, etc.
Program Telephone Exits Program Mode
Enter programming mode.
(Do not press [DN] button.)
Press LED Buttons 01 and 02.
LEDs 01 and 02 must be ON.
LCD Displays:
91 SELECT = 1
Renumber and Reset