Toshiba dk14 Water System User Manual


 
System & Station
Program *40 – Distributed Hunt Group Member Assignments
Strata DK Programming 5/99 3-121
System & Station
Program *40 Overview
This program assigns the members (station primary [DN] port numbers and hunting orders
[01~32] of Distributed Hunt (DH) groups [900~915]). When a member of a DH group is added or
deleted, all the other members’ hunting orders are automatically shifted to a new sequential order.
If Ground/Loop start CO lines ring DH Group member telephones, use Program 81~89 to assign
the selected CO lines to ring the DH group (900~915); do not use 81, 84, and 87 to assign
[PDNs] or [PhDNs] to flash and ring on the DH Group member telephones. Instead, put the CO
lines in a pooled line group and put the appropriate
3 RRO HG /LQH*US buttons on the DH member
telephones. Do not assign DH Group member telephones to ring in Program 81~89.
To assign ANI/DNIS/DID/Tie and Internal calls to ring DH groups, use Program 04, 09,
71~
*
73, or 71 (1~3) as required and do not put DID or Tie line pooled or direct line buttons on
DH member telephones. These calls ring the DH member telephone [PDN].
Each port assigned to a Program 31 Voice Mail Group should also be assigned to a dedicated
Distributed Hunt Group. (See Program 31 record sheet overview for Voice Mail/Distributed Hunt
program example.)