Filter
Top Products
Least Cost Routing
Program 50-6 – LCR Dial 0 (Zero) Time-out
Strata DK Programming 5/99 5-9
Least Cost Routing
Program 50-6 – LCR Dial 0 (Zero) Time-out
Processor Type:
DK14, DK40i, All RCTUs
Program Type:
Least Cost Routing
Initialized Default:
Assigns an LCR Dial Zero Time-out value of 06
Program 50-6 Overview
Enter the maximum number of seconds LCR waits for a user to dial additional digits after a 0,
before it routes the call to an operator for assistance. LCR waits this number of seconds to receive
additional digits that indicate charge calls, collect calls or other 0+ calls.
♦ The allowed range is 04~10 seconds. Always enter two digits.
♦ Dial 0 calls will be restricted when using 0 + Credit Card calling (Program 43) if a telephone
number is not dialed after dialing 0 or if Dial 0 is restricted in Program 46 (10~80).
Overview for Programs 51~54
These programs provide the system with directions for routing all possible calls, made by all
possible users at all possible times of day. Tables for Programs 51~54 appear on LCR Route Plan
Numbers 1~16. The following instructions show how to fill in individual tables within the plans.
Each of the following program tables must be completed for all plans.
Programs 51~54 defines LCR route plans (quantities given below):
These separate plans provide the customer flexibility enough to route different area codes and
exception office codes over different line groups.
Processor
LCR Route
Plans
Processor
LCR Route
Plans
DK14 8 RCTUBA/BB 8
DK40i 8 RCTUC/D 16
RCTUA 8 RCTUE/F 16
DATA = Time-out Value
Enter a time-out value from 04~10 seconds long.
SELECT = 6