Filter
Top Products
Pro Sweep Page 4 -- 9 Electrical System
Dump Beeper
The dump beeper sounds to notify the operator and by-
standers when the sweeper is raised for the hopper
dump function. The beeper is attached to the frame in
front of the RH wheel (Fig. 6).
Testing
1. Position sweeper on a level surface with dump hop-
per lowered. If sweeper is attached to towing vehicle,
apply vehicle parking brake, stop engine and remove
key from the ignition switch.
2. To ensure that electrical power is removed from Pro
Sweep, disconnect sweeper power harness from tow
vehicle.
3. Remove cover from frame to access dump beeper.
4. Disconnect wire harness connector from beeper.
IMPORTANT: Make sure to observe polarity on the
beeperterminals when testing. Damagetothebeep-
er may result from an improper connection.
5. Correctly connect 12VDC source to the beeper ter-
minals (Fig. 7).
6. Beeper should sound as long as 12VDC is con-
nected to the beeper terminals.
7. Disconnect voltage source from the beeper. Recon-
nect wire harness connector to beeper.
8. Secure cover toframe. Connect sweeperpower har-
ness to tow vehicle.
1. Cover
2. Cap screw (3 used)
3. Washer (3 used)
4. Dump beeper
5. Tinnerman nut (3 used)
Figure 6
2
3
1
5
4
FRONT
RIGHT
1. Top view
2. Bottom view
3. Positive (+) terminal
4. Negative (--) terminal
Figure 7
1
2
3
4
Electrical
System