Filter
Top Products
Output Voltage Requirements
26 315889-002
2.11 Shut-Down Response - REQUIRED
Once the VRM/EVRD is operating after power-up, if either the Output Enable signal is
de-asserted or a specific VID off code is received, the VRM/EVRD must turn off its
output (the output should go to high impedance) within 500 ms and latch off until
power is cycled. If the extended VR 10 VID table is selected, the VRM/EVRD should turn
off its output if VID [6:0] = XX11111. If the VR 11.0 VID table is selected, there are
four VID off states; VID [6:0] = 0000000, 0000001, 1111110, or 1111111.
§