Heat & Glo LifeStyle XLR-PLUS-N-AU Indoor Fireplace User Manual


  Open as PDF
of 77
 
Heat & Glo • XLR-PLUS-N-AU, XLR-PLUS-PB-AU • 2264-900 Rev. M • 7/12 60
A. RemoveFixedGlassAssembly
See Section 14.E.
B. RemovetheShippingMaterials
Remove shipping materials from inside or underneath the
rebox. The standard black rock media and manual bag
assembly are also shipped underneath the rebox.
C. CleantheAppliance
Clean/vacuum any sawdust that may have accumulated
inside the rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
14
ApplianceSetup
Figure14.1FixedGlassAssembly
E. FixedGlassAssembly
WARNING! Risk of Asphyxiation! Handle xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
RemovingFixedGlassAssembly
1. Remove the decorative front.
2. Locate the two spring latches that are on the upper left
and right of the replace.
3. Use both index ngers to release spring latches. See
Figure 14.1.
4. Allow glass to tilt forward. Grasp glass on the upper
right and left sides and lift glass “up” and “out.”
ReplacingFixedGlassAssembly
1. Locate glide tabs on lower left and right corners.
2. Grasp glass on upper right and left sides and tilt bot-
tom of glass assembly toward replace.
3. Allow of the bottom gasketing of the glass assembly to
touch the face of the replace.
4. Put pressure on the glass as you allow the glass assem-
bly to drop into the two lower tabs. See Figure 14.1.
5. Tilt top of glass towards replace and engage both top
spring latches
LOWER SPRING LATCH
UPPER SPRING LATCH
F. InstalltheMesh
The mesh front is included with the Tonic front. The Mar-
tini tinted glass front does not include mesh.
1. Place Tonic glass lip shields in position.
2. Place mesh into position with retaining bolts removed.
3. Thread retaining bolts into mating threads to retain
mesh as shown. See Figure 14.2.
MESH
RETAINING
BOLTS
Figure14.2MeshInstallation
Meshsplinefacingout.
 previous next