Heat & Glo LifeStyle XLR-PLUS-N-AU Indoor Fireplace User Manual


  Open as PDF
of 77
 
Heat & Glo • XLR-PLUS-N-AU, XLR-PLUS-PB-AU • 2264-900 Rev. M • 7/12 50
AboutONMode
• All functions can be accessed when the remote control
is in the ON mode.
• Only active functions will be displayed when the remote
control is in the ON mode. For example: if the fan is the
only function that’s active, the fan icon and ame will be
the only icon shown in the display.
AboutOFFMode
Only the following functions can be accessed in the OFF
mode:
• AUX1
• AUX2
Only active functions will be displayed when the remote
control is in the OFF mode.
TurningONtheFireplace
• Press the POWER button to turn the replace ON. The
replace will rst ignite the pilot. Once the pilot ame is
estabilshed the main burner will be lit.
NOTICE: Whenever the replace is cycled from OFF to
ON, the main burner will light on high for 10 seconds be-
fore returning to the previous user setting.
AdjustingFlameHeight
• Press the MENU button to activate the menu.
• Using the UP and DOWN arrows highlight the FLAME
icon and press SELECT.
• Use the UP and DOWN arrows to adjust the FLAME
HEIGHT, then press SELECT. The FLAMEHEIGHT
can be adjusted to 5 different settings.
NOTICE: FLAME HEIGHT will not be adjustable for rst
ten seconds when replace is turned on.
NOTICE: The system will remember the previous FLAME
HEIGHT setting and will automatically adjust after 10
seconds.
AdjustingFanSpeed
• Press the MENU button to activate the menu.
• Using the UP and DOWN arrows highlight the FAN icon
and press SELECT.
• Use the UP and DOWN arrows to adjust the FAN
SPEED, then press SELECT. The FAN SPEED can be
adjusted to 3 different settings: HIGH, MEDIUM, LOW.
NOTICE: The fan has a timer built into the control module.
After the replace is turned ON the timer will wait for 3
minutes before turning on the fan. In addition, the fan
will remain on for 12 minutes after the replace has been
turned OFF.
NOTICE: Whenever the fan is turned ON, the FAN will start
up on the high setting for 10 seconds before adjusting to
the previous user setting.
AUX1Function(UnitdependentFunction)
• Press the MENU button to activate the menu.
• Using the UP and DOWN arrows highlight the AUX1 icon
and press SELECT.
• Use the UP and DOWN arrows to adjust the AUX1output,
then press SELECT. The AUX1function can be adjusted
to 4 different settings: HI, MED, LOW and OFF.
AUX2Function(UnitdependentFunction)
• Press the MENU button to activate the menu.
• Using the UP and DOWN arrows highlight the AUX2 icon
and press SELECT.
• Use the UP and DOWN arrows to turn the AUX2 ON or
OFF, then press SELECT. The AUX2function can be
either be turned ON or OFF.
NOTICE: When the replace is turned OFF both AUX1 and
AUX2 will be turned off. The AUX1 and AUX2 functions can
be activated from the remote’s OFF mode, when the ame
is off. When the replace is turned back ON, the AUX1
and AUX2 settings will be restored to the previous setting.
 previous next