Heat & Glo LifeStyle 8000CL-IPI-T Indoor Fireplace User Manual


 
Heat & Glo • 6000CL-IPI-S, 6000CL-IPI-T, 8000CL-IPI-S 8000CL-IPI-T • 2165-900 Rev. S • 9/12
64
Figure11
1
2
3
4
5
6
7
Figure7
2
3
1
1
2
3
4
Figure8
Figure9
Figure10
1
1
2
2
3
3
4
5 5
6
4
Log#3(SRV2168-703): Mate the slot located on the bottom of Log #3 with the right log placement tab on top of Log #1.
After slot and tab have been tted together, mate the groove located on the bottom of Log #3 with the horizontal grate bar
and far right grate tine. Log #3 will sit down on top of both the grate tine and the horizontal grate bar (see Figure 7.)
Log#4(SRV2168-704): Place Log #4 in the left log indentation on the burner top (see Figure 2). Slide Log # 4 from right to
left under Log #2 to t completely and securely into the indentation (see Figure 8). The back or Log # 4 should rest against
the far left grate tine as well as contact Log # 2.
Log#5(SRV2168-705): Place Log #5 in the right log indentation on the burner top (see Figure 2). Ensure the log ts
completely and securely in the indentation (see Figure 9). Log #5 should be pulled to the left hand side of log indentation.
Log#6(SRV2168-706): Mate the groove located on the lower end of Log #6 with the fourth tine (from left to right) as shown
in Figure 10. Set the other end of Log #6 on the at area located on top of Log #4 (see Figure 9). Log #6 will also rest against
center grate tine. When properly installed, Log #6 will rest securely on all 3 contact points, not allowing movement or shifting.
FLATAREA
LOGCONTACTSGRATETINES
LOG#6CONTACTSTOPOFLOG#4
RIGHTGRATETINE
RAISEDKNOT
LOG#4CONTACTSLOG#2
FLATAREA
LOCATING
NOTCH
Log#7(SRV2165-707): Place back (unnotched) end of Log
#7 on the at area on the top of Log #5. Log #7 must be
pulled tight to the locating notch. Pivot the front (notched)
end of Log #7 to the right until the notch of Log #7 contacts
the grate tine located 4th from the left as shown in Figure 11.
HORIZONTALGRATEBAR
2169-935B