Heat & Glo • 6000CL-IPI-S, 6000CL-IPI-T, 8000CL-IPI-S 8000CL-IPI-T • 2165-900 Rev. S • 9/12
54
Figure13.4FinishingMaterial1InchThickorLess
DOOR FIT
FINISHMATERIAL
THICKNESS
SEE
FIGURE
Folio Inside Any 13.6
Arcadia
Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
Halston
Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
Chateau
Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
MT Hammer
Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
Galleria
Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
CF Inside Any 13.6
DOOR
1 in. MAX.
FINISHING MATERIAL
(TOP EDGE)
Finishing materials 1 inch maximum thick.
Stop nishing material ush with opening.
FINISHING STRIP NOT USED
(See Figure 13.7 for
removal instructions)
NON-COMBUSTIBLE
FINISHING MATERIAL
C. Doors
Only doors certied for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and nishing material is going to be used on the replace,
you may use the table below which shows the door mod-
els and the nishing material thickness allowed.
FinishingMaterial:
1InchThickorLess
Remove Finishing Strips. See Figure 13.7.
NOTICE: Remove nishing strips before ring appliance.
Note:Finishing strips may be used to aid in positioning of
non-combustible facing materials for some of the facing and
door combinations specied in the table above. They must
be removed following nishing work. See gure 13.7.