Filter
Top Products
R-5627 Page 27
Electrical Junction Box Connection
Figure 47
JUNCTION
BOX
NEUTRAL
BLACK
GROUND
WHITE
Attention: Only, after the fireplace has been converted to a
heater can a 24 volt wall thermostat or battery operated remote
control with thermostat, FRBTC-1 be used. See installation of
heater baffle on Page 5.
OPERATING INSTRUCTIONS
Provided on the intermittent pilot wiring harness are two (2) stripped and
bare wires that are labeled THERMOSTAT. The wires will be used for
attachment of 24 volt thermostat, optional FWS-1 wall switch or will
attach into the receiver on an optional FRBC-1, FRBTC-1 or FREC-1
remote control.
Installation of Remote Receiver
Place remote receiver on the floor of fireplace behind the louver as far
forward as possible.
Attention: The velcro loop and hook are not necessary in this installation
but can be used to secure remote receiver.