Filter
Top Products
BE-1204B-BC • BE-1206B-BC 2-5
Chapter 2 Embroidering Procedures
Switches at Machine Heads
W1257Q
! Stop switch
Stops embroidering operation. "Release stop SW to operate!" is displayed on the screen as
soon as the machine stops.
Refer to "Stopping the machine" ( page 6-3) to stop flashing.
In BE-1206B-BC models, this switch is located between the head 2 and 3, and also between the
head 5 and 6.
In BE-1204B-BC models, this switch is located between the head 1 and 2, and also between the
head 3 and 4.
! Start switch
Starts embroidering. Holding down this switch executes embroidering at a low speed.
When resuming embroidering after a stop, release stop before pressing this switch. Refer to
"Stopping the machine" ( page 6-3) for details.
In BE-1206B-BC models, this switch is located between the head 2 and 3, and also between the
head 5 and 6.
In BE-1204B-BC models, this switch is located between the head 1 and 2, and also between the
head 3 and 4.
! STEP BACK/FWD switch
When BACK switch is pressed, the machine steps back. When FWD switch is pressed, the
machine steps forward. If you keep the switch pressed for a while, the machine will continue
stepping even after you let the switch alone.
If any error occurs, it can be reset.
When the sewing is suspended during the area checking, pushing this switch can move the head to
the previous or the next vertex of the outlined rectangle pattern.
In BE-1206B-BC models, switches are located between the head 1 and 2, and also between the
head 5 and 6.
In BE-1204B-BC models, switches are located between the head 1 and 2, and also between the
head 3 and 4.
Stop switch
Start switch
Step forward switchStep back switch