Filter
Top Products
1-10 BE-1204B-BC • BE-1206B-BC
Chapter 1 Preparations of operation
!
!!
! For embroidering with tubular square hoop or cap frame (lower position)
W1227Q
1. Attach four hexagon socket head cap screws to each of table parts R [1], M [2](six head models
only), and L [3] from the back.
2. Put the table backing plate [4] of each table on to the table guide bridge [5], and slide to the other
side. Insert the table backing plate [4] into the table backing rubber on the table support Rear [6].
3. Adjust table supports front [7] in height so as to make the table parallel with the floor.
4. Tighten all hexagon socket head cap screws [8] firmly.
[1]
[2]
[3]
[8]
[7]
[6]
[4]
[6]
[5]
[5]