Filter
Top Products
5-12 BE-1204B-BC • BE-1206B-BC
Chapter 5 Setting
Setting of Mending
Details of mending can be set in case of a thread breakage.
! Contents of each setting item are as described below.
Item Contents
For setting a mending end point (number of stitches before a thread breakage) within the
range of 1 ~ 10.
This function is previously set to 1 stitches upon shipments.
For setting whether to reset a thread breakage error automatically.
This function is previously set to
(Manual) upon shipments.
For resetting an error automatically
For resetting an error manually
For setting whether to stop embroidering temporarily at the mending end point
For stopping embroidering at the mending end point
For stopping embroidering temporarily at the mending end point and then starting all
heads automatically
For not stopping embroidering at the mending end point and continuing embroidering
Manually trim the lower thread immediately after resetting a thread breakage error if
feeding by stitch back is long (i.e., 40 to 50 mm or more) in this mode.
Set the thread trimming method to
.
For setting a thread trimming method using the immediately after resetting a thread
breakage error. (This setting is effective only once after resetting the error.)
For trimming both upper and lower threads
For trimming the lower thread only
For not trimming any thread
! Refer to "Mending" (→ Page 6-5).
1. Press
.
2. Select
by pressing
.
W0609Q
3. Press .
W0612Q