Brother 882-W02 Sewing Machine User Manual


 
SEWING THE STITCHES
140
d
Place the edge sewing sheet on top of the
needle plate cover.
Align the guides on the edge sewing sheet with the
sides of the needle plate cover, and then adjust the
position of the edge sewing sheet so that its cutout
aligns with the edges of the opening for the feed dogs.
Position the edge sewing sheet so that there is no gap
between it and the edges of the opening for the feed
dogs.
a Edge sewing sheet
b Guides on edge sewing sheet
c Sides of needle plate cover
a Edge sewing sheet
b Feed dogs
c Between the feed dogs and the edge sewing sheet
e
Press .
o Depending on the stitch, the straight stitch with the
middle (center) needle position is selected,
regardless of the preset stitch width.
* Regardless of the setting selected in the machine
settings screen, the brightness of the light changes to
“5”.
f
When the message shown below appears,
check that the vertical stitch alignment foot
“V” is attached and that the edge sewing
sheet is positioned, and then press .
o Then the edge sewing window appears.
Note
If the metal needle plate is visible between
the feed dogs and the edge sewing sheet,
the fabric may be incorrectly detected by the
built-in camera.
Memo
Before using the edge sewing sheet, peel off
the transparent sheet. After use, affix the
edge sewing sheet to the transparent sheet
to prevent it from collecting dust.
a Transparent sheet
Set a fully wound bobbin before starting to
use the edge sewing feature and built-in
camera. If you need to change the bobbin
while edge sewing, remove the edge sewing
sheet carefully and place it again after
changing the bobbin.
Note
After is pressed, the stitch width and
stitch length cannot be changed. Change
the stitch width and stitch length before
pressing .