Filter
Top Products
CTFID Connections | en 13
Bosch Security Systems, Inc. User’s Manual F.01U.141.545 | 3.09 | 2009.10
3.3 Connecting the AutoDome RS-232
Figure 3.4 Connecting the AutoDome RS-232 to the PC
Connecting the AutoDome to Your PC
1. Make the RS-232 cable using the table below.
2. Connect the DB9 connector to the Com port of the PC.
3. Connect P105 to the AutoDome.
4. Use coax to connect the Video output of the AutoDome to a CCTV monitor.
5. Reposition the slide switch located on the main board of the AutoDome. Slide the switch
toward the camera head, inward and away from the LEDs. See Figure 3.5.
Figure 3.5 RS-232
Number Description
1 AutoDome 200, 300, and 500 Series
2 PC running CTFID software
3RS-232
4 Coax to input of monitor
5 Typical CCTV monitor
Pin # Description
PC DB9
2RxD
3 TxD
5GnD
P105 (AutoDome 200, 300, 500)
5RxD
4 TxD
6GnD