Filter
Top Products
CTFID Connections | en 11
Bosch Security Systems, Inc. User’s Manual F.01U.141.545 | 3.09 | 2009.10
3.2 Connecting the VP-RS2BLNX Configuration Tool
It is recommended that the CTFID software be installed prior to connecting the hardware to
the serial port. Refer to Section 2 Installing the CTFID, page 6 for additional information.
To see the device output, use a CCTV monitor. Plug the coax connected to the imaging device
to one of the BNC connectors of the VP-RS2BLNX. Connect another coax between the second
BNC connector and the CCTV monitor. Ensure that the monitor is either auto-terminating or is
set to low impedance. See Figure 3.3 for an example of a typical CCTV monitor’s connections.
Figure 3.2 VP-RS2BLNX connections
Connecting the VP-RS2BLNX (Bilinx)
Figure 3.3 Connecting the VP-RS2BLNX Configuration Tool
Number Description
1 Power and serial connection
2 Selects mode and baud rate
3 BNC connections, passive loop-through, high impedance, video input 1 Vpp nominal,
2Vpp max.
Number Description
1 Typical AutoDome version 5.10 or higher, and any other Bilinx device
2Coax IN
3 Terminal block
4VP-RS2BLNX
5 PC running CTFID software
6 RS-232
7 Power supply (not provided)
8Coax OUT
9 Typical CCTV monitor