Agilent Technologies E4350B Water Heater User Manual


 
70 Language Dictionary
Table 7-2. Subsystem Commands Syntax (continued)
[SOURce:]
CURRent
[:LEVel]
[:IMMediate][:AMPLitude]<NRf+> Sets the output current level
:TRIGgered [:AMPLitude] <NRf+> Sets the triggered output current level
:MODE <mode> Sets the operating mode (FIX | SAS | TABL)
:PROTection
[:LEVel] <NRf+> Sets over-current protection level in Simulator and Table modes
:STATe <bool> Enable/Disable Fixed mode current limit protection (0,1,OFF,ON).
:SASimulator
:ISC <NRf+> Sets the short-circuit current in simulator mode
:IMP <NRf+> Sets the maximum-power current in simulator mode
:TABLe
:NAME [<name>] Selects a table for use when the operating mode is Table
:OFFSet <NRf+> Sets the offset current when the operating mode is Table
DIGital
:DATA [:VALue] <NRf+> Sets and reads the digital control port
VOLTage
[:LEVel]
[:IMMediate][:AMPLitude] <NRf+> Sets the dc voltage level
:TRIGgered [:AMPLitude] <NRf+> Sets the triggered voltage level
:PROTection [:LEVel] <n> Sets the overvoltage protection threshold
:SASimulator
:VOC <NRf+> Sets the open-circuit voltage in simulator mode
:VMP <NRf+> Sets the maximum-power voltage in simulator mode
:TABLe
:OFFSet <NRf+> Sets the offset voltage when the operating mode is Table
STATus
:OPERation
[:EVENt]? Returns the value of the event register
:CONDition? Returns the value of the condition register
:ENABle <NRf> Enables specific bits in the Event register
:NTRansition<NRf> Sets the Negative transition filter
:PTRansition<NRf> Sets the Positive transition filter
:PRESet Presets all enable and transition registers to power-on
:QUEStionable
[:EVENt]? Returns the value of the event register
:CONDition? Returns the value of the condition register
:ENABle <NRf Enables specific bits in the Event register
:NTRansition<NRf> Sets the Negative transition filter
:PTRansition<NRf> Sets the Positive transition filter
SYSTem
:ERRor? Returns the error number and error string
:VERSion? Returns the SCPI version number
TRIGger
[:IMMediate] Triggers the measurement immediately
:SOURce <source> Sets the trigger source (BUS)
Table 7-3 list the programming parameters for each of the models in Fixed mode