Filter
Top Products
At a time like this
In case of the misplaced or discharge remote controller, temporary Automatic operation is available from RESET button on the indoor unit.
If the remote controller is not available
In case of 2 air conditioners are installed near each other
Q When operating Q To stop
•
Fully Automatic operation. (Temperature and air
volume are set automatically).
•
Operation lamp turns on.
A - B Selection
To separate using of remote control for each indoor unit in case of 2 air conditioners are installed adjacent to each
other.
Indoor unit and remote controller are set to A when shipped from the factory.
•
Automatic cleaning is not operated.
•
Operation lamp turns off.
B setting
(Blue) (Orange)
1 second
(Blue) (Orange)
1 second
again
How to set both the indoor unit and remote controller to B
1
Press Reset on the display portion of the indoor unit for approx. 1 second to start automatic
operation.
2 Press and hold
CHECK
then press
MODE
on the remote controller, remote controller will show B on
display and send signal to the Indoor unit.
Make sure that the Indoor unit can receive signal of remote controller while process this step.
3 Check that the remote controller can operate the indoor unit.
(Blue) (Orange)
1 second
•
Cooling starts after 10 seconds with a “Pi” sound. However,
continue to press it.
Setting completes when beep sounds 5 times as “Pi Pi Pi Pi Pi”
and the operation lamp blinks.
•
To release it, repeat the operation of (1) – (2).
(In this case, the operation lamp does not blink).
Start the operation smoothly and reduce the operating noise.
Concern about the operating noise
1 Press 20 seconds
2 Stop Cooling
Quiet
MODE SWING FAN
AIR FLOW
FIX FIX
ECO
Hi POWER
PURE
COMFORT
SLEEP
POWER-SEL
TEMP.
PRESET
When setting is complete.
(Blue) (Orange)
20 seconds
P
i
P
i
P
i
P
i
P
i
34
1110650159_(31-38)_EN.indd 34
1110650159_(31-38)_EN.indd 34
2/28/11 2:11 PM
2/28/11 2:11 PM