Quadra-Fire 7046-137C Indoor Fireplace User Manual


 
Page 6
7046-137C
December 15, 2009
R
2700-I ACC Wood Insert
1
Listing and Code Approvals
The Quadra-Fire 2700-I Wood Insert (ACC) meets the U.S.
Environmental Protection Agency’s 1990 particulate emis-
sion standards.
A. Appliance Certication
C. Glass Specications
D. BTU & Efciency Specications
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
B. Mobile Home Approved
EPA Certied:
.5 grams per hour
Efciency:
up to 84.1%
BTU Output:
10,450 to 16,400
Heating Capacity:
up to 1800 sq ft depending
on climate zone
Vent Size:
6 inches
Firebox Size:
1.75 cubic feet
Max Wood Length:
18 inches
Fuel:
Cord Wood
Shipping Weight:
240 lbs
Model:
2700-I (ACC) Insert
Laboratory: OMNI Test Laboratories, Inc.
Report No:
061-S-78-6.2, 061-S-52b-
Type:
Solid Fuel Type, Listed Room Heater
Standard: UL1482 and ULC S628-9 and
(UM) 84-HUD, Mobile Home
Approved.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products,
their specications and/or price without notice.
NOTE: This installation must conform with local codes. In the
absence of local codes you must comply with the UL1482,
(UM) 84-HUD and NPFA211 in the U.S.A. and the ULC S628-
9 and CAN/CSA-B65 Installation Codes in Canada.
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an out-
side combustion air inlet is provided.
The structural integrity of the mobile home oor, ceiling,
and walls must be maintained.
The appliance must be properly grounded to the frame
of the mobile home with #8 copper ground wire, and use
only listed double-wall connector pipe.
Outside Air Kit, part OAK-ACC must be installed in a mo-
bile home installation.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualied
installer, service agency or your dealer.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
Installation and use of any damaged appliance.
Modication of the appliance.
Installation other than as instructed by Hearth & Home
Technologies.
Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Operating appliance without fully assembling all
components.
Operating appliance without legs attached (if supplied with
unit).
Do NOT Overre - If appliance or chimney connector glows,
you are overring.
Any such action that may cause a re hazard.
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions: