Quadra-Fire 7046-137C Indoor Fireplace User Manual


 
Page 44
7046-137C
December 15, 2009
R
2700-I ACC Wood Insert
Part No. ADJSPT-3, size 3-1/2” x 48-1/2”
DOUBLE-SIDED TAPE
DOUBLE-SIDED TAPE
SCREWS ARE CIRCLED
EXPLODED VIEW OF SCISSORS
Figure 44.1
EXPAND SCISSORS TO DESIRED HEIGHT
CUT TOP EDGE
OF TRIM, NOT
BOTTOM EDGE
INSTALL FRONT TRIM
LAST. CORNERS
OVERLAP SIDE TRIM
PIECES
I. Zero Clearance Adjustable Trim Support,
Adjustable from 2 inches to 10 inches
Included in Kit: (1) Trim Top, (1) Trim Front, (2) Trim Sides,
Double-Sided Tape (already installed)
Tools Needed: Phillips Head Screwdriver, Sheet Metal
Shears, Measuring Tape, Gloves
1. The 10 screws on each set of scissors will already be
loose when shipped. Figure 44.1.
2. Expand scissors to desired height. Tighten screws
to hold in place using Phillips Head screwdriver. See
Figure 44.2.
. Measure front and side trims to required height to cover
scissors and mark pieces for cutting. Cut excess mate-
rial from top of trim’s edge, not bottom. This edge will
be sharp; wear gloves to prevent injury to your hands.
Figure 44.2.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge ts under lip of top trim, so it
allows for some variance in your straight edge.
5. The double-sided tape that holds front and side trims
to scissors has a particularly powerful bonding adhe-
sive. Adjustments are extremely difcult once trim has
adhered to tape. Do a dry run rst without removing
paper from tape.
6. Place cut edge of trim under top lip and into position
on scissors. Place side pieces on rst and then front
piece. The front piece overlaps side pieces.
7. Once you are satised with the positioning, remove
trim and set aside.
8. Remove the paper from double-sided tape that is
to accept trim side. Align side and then press hard
against tape to secure side piece. Repeat for other
side. Install front trim piece last.
9.
There are  holes in the back ange of the top to
secure it to the wall if necessary. Use the appropriate
fastener for the type of wall material, i.e., brick, sheet-
rock, etc.
Figure 44.2
Figure 44.3 - Installation Complete