Filter
Top Products
Page 18
7046-137C
December 15, 2009
R
2700-I ACC Wood Insert
• Frequency: As desired
• By: Homeowner
• Clean glass with a non-abrasive glass cleaner. Abrasive
cleaners may scratch and cause glass to crack.
• If the deposits on the glass are not very heavy, normal
glass cleaners work well. Heavier deposits may be
removed by using a damp cloth dipped in wood ashes or
by using a commercially available oven cleaner.
• After using an oven cleaner, it is advisable to remove any
residue with a glass cleaner or soap and water. Oven
cleaner left on during the next ring can permanently
stain the glass and damage the nish on plated metal
surfaces.
• A portion of the combustion air entering the rebox is de-
ected down over the inside of the door glass.
• This air ow “washes” the glass, helping to keep smoke
from adhering to its surface.
• When operated at a low burn rate, less air will be owing
over the glass and the smoky, relatively cool condition of
a low re will cause the glass to become coated.
• Operating the appliance with the Burn Rate Air Control
and Start-Up Air Control all the way open for 15-20 min-
utes should remove the built up coating.
E. Glass Cleaning
CAUTION! Handle glass assembly with care. Glass is
breakable.
• Avoid striking, scratching or slamming glass
• Avoid abrasive cleaners
Replace the rebrick if they become crumbly and/or if
there is a 1/4 inch (6.5mm) gap between the bricks.
The rebox is lined with rebrick, which has exceptional
insulating properties. Do not use a grate; simply build
a re on the rebox oor. Do not operate appliance
without rebrick.
1. After the coals have completely cooled, remove all
old brick and ash from unit and vacuum rebox.
2. Remove new brick set from box and lay out to
diagram shown.
.
Install rear bricks on the top of the rear air channel.
F. Inspect Firebrick
• Frequency: After each ash removal
• By: Homeowner
Use Part 82-0550 when ordering individual brick. Provide
brick dimension or copy this page, mark the desired brick and
take it to your authorized dealer.
Figure 18.2
No. Brick Size Qty
1 9” x 4-1/2” x 1-1/4” 11
2 Bottom Back, see diagram for size 2
3 Bottom Back Middle, see diagram for size 3
4 Bottom Back Front, see diagram for size 2
1
1
1
1
1
1
1
1
1
1
1
2
2
4
3
3
4
8-3/8 in.
4-1/2 in.
7-3/4 in.
2
6-1/2 in.
4-1/2 in.
7-3/8 in.
3
8-1/8 in.
4-1/2 in.
7-1/4 in.
4
Figure 18.1
4. Install side bricks. Slide top of brick under clips on side
of rebox and push the bottom of the brick until it is ush
with the side of the unit.
5. Lay bottom bricks in unit.
F. Inspect Firebrick (Cont’d)