Quadra-Fire 7046-137C Indoor Fireplace User Manual


 
December 15, 2009
7046-137C
Page 41
2700-I ACC Wood Insert
R
F. Surround & Trim Kit Installation
1. Lay surround face down on a protected surface to pre-
vent scratching.
2. Using a Phillips head screw driver attach the side sur-
rounds to the top surround using (2) #8 sheet metal
screws on each side provided with the kit. Figure 41.2.
. Lay the trim face down and place the corner brackets into
position.
4. Using a standard at screw driver tighten the corner
brackets. Figure 41.3.
5. Slide the assembled trim set over the surround set. and
then over the appliace. Figure 41.4.
Secure 2 Side Surrounds to
Top Surround
Figure 41.2
Corner Brackets
Figure 41.3
E. Securing Appliance to Stove Pipe/Liner
1. Once you have the appliance in place and secured,
remove the tube channel assembly, bafe board and
ceramic blanket. Detailed instructions are found on
pages 23 and 24.
2. Reach up through the ue opening and grab the attach-
ment bar and pull down inside ue opening. Figure
41.1.
. Insert the 5/16 bolts inside the cast ue and through the
chimney mounting bar. Securely tighten the nuts. Fas-
teners are provided.
4. Re-install the tube channel assembly, bafe board,
ceramic blanket and bafe protection channel.
Figure 41.1
5/16 Bolts
Attachment Bar
5/16 Nuts
Slide Surround and
Trim over Appliance
Figure 41.4