Filter
Top Products
Page 22
7046-137C
December 15, 2009
R
2700-I ACC Wood Insert
C. Blower Replacement
1. Using a 5/2 Allen wrench, remove 4 blower housing
mounting bolts and slide assembly out. Figure 22.1.
2. Disconnect the wires from the blower.
. Using a Phillips head screw driver, remove 4 screws.
Figure 22.2.
4. Remove blower from the blower housing assembly.
5. Install new blower and secure with the same 4
screws.
6. Re-connect the wires to the blower.
7. Slide the assembly back into position under the ash
lip and secure with the 4 mounting bolts.
Shock Risk.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded prong
receptacle.
• Route cord away from appliance.
•
Do NOT route cord under or in front of appliance.
CAUTION
Remove 4 Screws
& Remove Blower
from Housing
Figure 22.2
Remove Bolts and Slide
Blower Assembly Out
Figure 22.1
Do NOT allow hot coals or embers to overow ash lip
•
May melt protective wire coating on fan power cord
causing electrical short, re or injury
Fire Risk.
WARNING