Filter
Top Products
Getting Started
9
English
1.2 Setup Overview
The following steps briefly describe the setup procedure required before you can
use the BL-WV10 to view camera images. Detailed procedures can be found in this
document.
1. Insert the batteries in the remote control.
2. Connect the BL-WV10 to your TV.
3. Use the BL-WV10’s Easy Network Setup utility to configure the BL-WV10.
4. Connect the cameras to the BL-WV10 and/or router.
5. Use the BL-WV10’s Quick Setup utility to configure the cameras.
6. Confirm that camera images are viewable on the TV.
7. Place the cameras where you plan to use them.
1.2.1 Connection Examples
There are 2 ways to connect your cameras to the BL-WV10. Determine which
method you will use, and refer to the pages listed below.
When using a router
If you will connect the BL-WV10 to a router, see page 10.
When not using a router
If you will not connect the BL-WV10 to a router, see page 15.
Internet
Router
PC
BL-WV10
TV
BL-WV10
TV
BL-WV10_GS-en.book Page 9 Wednesday, January 25, 2006 5:18 PM