Filter
Top Products
Getting Started
25
English
The timer could not be set
because the recording
time overlaps with another
timer. Set a different start
and/or end time. (ED7)
This error is displayed if the recording time overlaps
with another timer recording program.
• Reset using different specifications for the
recording.
To use the sensor, first
enter the Administrator
user name and password
on this camera’s [User
Info] screen. (ED8)
This error is displayed if the user name and password
required for sensor use for remote cameras are
different than those of the administrator.
• Enter the administrator name and password
in the [User Info] screen.
No camera name entered.
(ED9)
This error is displayed when the name is not set for a
newly registered remote camera.
• Enter a camera name.
The IP address and port
are not set. (EE1)
This error is displayed when the IP address and port
number are not set for a newly registered remote
camera.
• Enter a camera address.
There was a recording
error. (EE2)
This error is displayed if for some reason, during
standard recording, the signal from a camera is lost.
• Make sure camera monitoring is possible,
then try recording again.
This camera is used for
Sensor Alert mode.
Set Sensor Alert to [-] on
the [Camera Sensors]
screen. (EE3)
This error is displayed when you attempt to erase a
camera that has been set for Sensor Alert.
• Turn off the camera’s sensor in the [Camera
Sensors] section of the [Sensor Alert] screen.
Set [Sensor Alert] to [-].
(EE4)
This error is displayed when you attempt to disable a
remote camera’s sensor when that camera has been
set for Sensor Alert.
• Turn off the camera’s sensor in the [Camera
Sensors] section of the [Sensor Alert] screen.
This sensor is used for
sensor recording.
Turn off the record
program. (EE5)
This error is displayed when you attempt to disable a
remote camera’s sensor when that camera has been
set for timer recording using continuous sensor
recording.
• Deselect the camera chosen for continuous
sensor recording or re-do the settings with a
different camera.
Error Message Causes and Solutions
BL-WV10_GS-en.book Page 25 Wednesday, January 25, 2006 5:18 PM