Filter
Top Products
Getting Started
35
English
I cannot use Quick Setup. Quick Setup will work for a maximum of 8 cameras.
Is the Ethernet cable connected properly?
• If the Ethernet cable is connected properly,
the LAN indicator will be lit green.
Quick Setup can only be performed within 20 minutes
of turning on a camera that still has its default settings
(as at time of purchase).
• Turn the camera on again.
When performing Quick Setup on a wireless camera
with a wired/wireless switch, such as the BL-C30, is
the camera switch set to wired?
When performing Quick Setup on a computer for
cameras already initialized, is the IP address the
same as that for the BL-WV10?
No router is displayed,
even though one is
connected.
Was the router turned on before the BL-WV10?
• Turn the router on and wait 2 minutes or more
before turning the BL-WV10 on.
Is the DHCP server option in the router settings
turned off?
• Quick Setup cannot be performed. Launch
the BL-WV10 in normal mode, and manually
perform network settings from the Setup
menu.
Display indicates no
wireless router.
The BL-WV10 does not support wireless routers.
Display indicates that no
wireless router was found.
The BL-WV10 does not support wireless routers.
Camera Quick Setup fails. Are you following the procedures shown in this
document?
• If registration fails, re-initialize the camera,
turn the BL-WV10 off and then on again, and
re-perform Quick Setup.
In addition to the router, is there another Panasonic
device serving as an access point?
• Remove that access point from the network,
and turn the BL-WV10 off and then on again.
[Setting wireless
parameters...] appears.
This message is displayed when another BL-WV10 is
connected. It indicates that the connected devices
will have the same wireless settings configured for
them.
Issue Causes and Solutions
BL-WV10_GS-en.book Page 35 Wednesday, January 25, 2006 5:18 PM